In the "good old days" ( ZAPTEL ) Channel => had to be the last line in a section. Everything after channel => was ignored.
Seems that has not changed. A hard learned lesson by many ! Eric Merkel (Mail Lists) wrote: > > Thanks you were exactly right. I had a problem in my chan_dadhi.conf > file. Basically, I had the channels defined before the signaling and > it wouldn’t load. It did not show any errors that I could see on > startup and there were no messages in the /var/log/asterisk/messages > but when doing a “load chan_dahdi.so” from the command line showed me > the problem. > > Thanks again! > > ===== > > Eric Merkel > > [email protected] > > *From:* [email protected] > [mailto:[email protected]] *On Behalf Of > *Anthony Francis - Handy Networks LLC > *Sent:* 2010-01-21 15:50 > *To:* Asterisk Users Mailing List - Non-Commercial Discussion > *Subject:* Re: [asterisk-users] pri CLI command not available > > This is often caused by the dahdi module not loading, check > /var/log/asterisk/messages for the reason, or better yet, from the cli > load the module manually and see the error in real time. If I had to > guess I would say it is a configuration error. > > Thank you and have a nice day, > > Anthony Francis > > *From:* [email protected] > [mailto:[email protected]] *On Behalf Of *Eric > Merkel (Mail Lists) > *Sent:* Thursday, January 21, 2010 1:41 PM > *To:* [email protected] > *Subject:* [asterisk-users] pri CLI command not available > > I am in the process of trying to terminate a PRI into a new * server. > The server has an old T100P T1/PRI card in it. I have compiled the > following on Centos 5.4. > > dahdi-linux-complete-2.2.1+2.2.1 > > libpri-1.4.10.2 > > asterisk-1.4.29 > > Everything seems to have compiled fine. DAHDI reports “Found a > Wildcard: Digium Wildcard T100P T1/PRI” on bootup. Dahdi_tool shows > that the span is up and active with no alarms however the phone > company is not seeing the trunkgroup going into service. I was wanting > to take a look at the PRI debugs but for some reason the CLI “pri” > option is not available. I libpri compiled without any issues prior to > compiling asterisk. What would cause the “pri debug” commands to not > be available in the CLI? > > ===== > > Eric Merkel > > [email protected] > > ------------------------------------------------------------------------ > > > > Checked by AVG - www.avg.com > Version: 9.0.730 / Virus Database: 271.1.1/2635 - Release Date: 01/20/10 > 14:18:00 > > -- Dog is my co-pilot -- _____________________________________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
