On 17/11/2014 9:24 PM, Olivier wrote:
2014-11-17 12:55 GMT+01:00 Larry Moore<[email protected]>:
On 17/11/2014 7:34 PM, Larry Moore wrote:
On 17/11/2014 6:42 PM, Olivier wrote:
Hello,
If I'm not mistaken, it is not possible to get T.38 on a SPA3102 FXO
port (it is possible with the FXS port).
Do you know, by experience preferably, if this is possible with an
SPA8800 FXO port ?
Reading your question again, no the FXO port will not perform T.38, you are
limited to G711 pass-through, from memory my SPA8800 was on the LAN the
Asterisk PBX was attached and faxes were pretty good though I would have
preferred to see T.38.
Thanks for sharing this here:
while it's not always easy to discover what a product can do, it's
harder to know what it CANNOT do.
Thanks
Grandstream ATA's support T.38 on the FXO port.
I had a lot of trouble to localize SPA3102 settings for Caller ID
presentation, for instance.
I was fortunate that there is plenty of information for configuring an
SPA3000 & SPA3102 for my country.
Perhaps page 53 of this document
http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/csbpvga/ata/administration/guide/ATA_AG_v3_NC-WEB.pdf
may help, the other parameter I needed to adjust to receive Caller ID
was the 'PSTN Answer Delay' setting.
I can't recall any great pain setting up an HT-503, I suspect I based
settings upon an SPA3102/SPA8800, the T.38 faxing on the FXO was
successful after a Firmware Upgrade, it was a couple of years ago when I
was setting this up.
Larry.
--
_____________________________________________________________________
-- Bandwidth and Colocation Provided by http://www.api-digital.com --
New to Asterisk? Join us for a live introductory webinar every Thurs:
http://www.asterisk.org/hello
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
