This is quite common in some countries. Analogue lines are some times configured for 'calling party clearing', where an inbound call to an analogue line will hold the line for some minutes before timing out.
Might this explain the behaviour? Rgds Tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Walter Klomp Sent: 29 July 2004 15:44 To: [EMAIL PROTECTED] Subject: [Asterisk-Users] Zaptel doesn't see remote hangup ? euro-isdn Hi Just received my spanky new TE405P today to replace my Cisco gateway... After much fiddling (I forgot to switch it to E1) I got it to work and everything "seems" to work perfectly on our ISDN PRI. If I dial-in from the PSTN to a SIP phone, the call goes through and if I hangup either the SIP phone or the remote end, the call gets disconnected and destroyed However, if I dial-in from the SIP phone to my PSTN and then hang up my PSTN phone, the call does not get disconnected. My SIP phone goes quiet but doesn't disconnect. If I a few seconds later pick up the PSTN phone again, the connection is still there. Only if I hangup the SIP phone, the call gets destroyed. It seems that Zap doesn't see the remote hangup... Here is my Zaptel config and my Zapata config. I presume the extensions config etc are OK as my call-flow never changed and things were working fine with my AS5300. Am I missing something ? How do I debug the Zap channels ? Cheers, Walter Klomp /etc/zaptel.conf span=1,1,0,ccs,hdb3,crc4 # This is the line in question... span=2,1,0,ccs,hdb3,crc4 # not used yet span=3,0,0,ccs,hdb3,crc4 # not used yet span=4,0,0,ccs,hdb3,crc4 # not used yet # Span 1 bchan=1-15 dchan=16 bchan=17-31 # Span 2 bchan=32-46 dchan=47 bchan=48-62 # Span 3 bchan=63-77 dchan=78 bchan=79-93 # Span 4 bchan=94-108 dchan=109 bchan=110-124 alaw=1-124 loadzone=uk defaultzone=uk /etc/asterisk/zapata.conf [channels] context=default switchtype=euroisdn signalling=pri_cpe usecallerid=yes hidecallerid=no callwaiting=yes callwaitingcallerid=yes threewaycalling=yes transfer=yes cancallforward=yes echocancel=yes rxgain=0.0 txgain=0.0 immediate=no ; Channels inherit configuration above them ; Span 1 group=1 signalling=pri_cpe channel => 1-15 channel => 17-31 ; Span 2 group=2 signalling=pri_cpe channel => 32-46 channel => 48-62 ; Span 3 group=3 signalling=pri_cpe channel => 63-77 channel => 79-93 ; Span 4 group=4 signalling=pri_cpe channel => 94-108 channel => 110-124 _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users