Hi,
I have a problem with zaphfc in NT mode.
I installed the card, the software and made a isdn crossover cable (with two 100Ohm resistors).
But if I pickup the phone, there is no dialtone. Also I can't ring the phone from xlite.
if I load the zaphfc module with debug=1 I see a message when I pickup the phone.
------
zaphfc: card 0 RX 8 bytes [ 0xfc 0xff 0x3 0xf 0x2c 0x4d 0x1 0xff ...]
zaphfc: card 0 RX 2 bytes [ 0x60 0xe4 !]
------
But two seconds later I can read on my phone's display : "Line Failure".
What could cause that ?
I installed the latest bristuff ( Asterisk 1.0.2-BRIstuffed-0.2.0-RC2b ).
------- /etc/zaptel.conf ------- loadzone=nl defaultzone=nl
span=1,1,3,ccs,ami bchan=1-2 dchan=3 --------
I loaded the module with: insmod ./zaphfc.ko modes=1
-------- /etc/asterisk/zapata.conf -------- [channels] switchtype = euroisdn ;signalling = bri_net signalling = bri_net_ptmp pridialplan = local prilocaldialplan = local echocancel = yes overlapdial = no immediate = no usecallerid = yes group = 1 context = zapincoming channel => 1-2 --------
-------- extensions.conf --------- [fromxlite] exten => 6,1,Dial(Zap/g1/4758645,60,r) ---------
-----
load modules
-----
zaptel: no version for "struct_module" found: kernel tainted.
Zapata Telephony Interface Registered on major 196
zaphfc: CCD/Billion/Asuscom 2BD0 configured at mem 0xc49b9e00 fifo 0xc2678000(0x2678000) IRQ 9 HZ 1000
zaphfc: Card 0 configured for NT mode
zaphfc: 1 hfc-pci card(s) in this box.
Registered tone zone 3 (Netherlands)
zaphfc: card 0 layer 1 state = G2
zaphfc: card 0 layer 1 state = G3
-------
Thank you in advance !
Sebastian _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
