you are running sip debug from the bash shell, not the cli. in the shell, run 'asterisk -vvvr'
this will open the cli. --dalon On 4/12/05, Brian Watters <[EMAIL PROTECTED]> wrote: > Johnathan, > > Thanks for your reply .. > > [EMAIL PROTECTED]:somethinginnocuous:[EMAIL PROTECTED] > advoice.com > > Note when I attempt to use "sip debug" from the CLI I get > > [EMAIL PROTECTED] /]# sip debug > -bash: sip: command not found > [EMAIL PROTECTED] /]# > > However via the Web GUI I can see the following .. > > Sip Peers > Host Username Refresh State > sip.broadvoice.com:5060 [EMAIL PROTECTED] 3584 Registered > Verbosity is at least 3 > > Sip Registry > Name/username Host Dyn Nat ACL Mask Port > Status > bv/5594734514 147.135.8.128 N 255.255.255.255 5060 OK > (60 ms) > 500/500 (Unspecified) D 255.255.255.255 0 > Unmonitored > 300/300 (Unspecified) D 255.255.255.255 0 > Unmonitored > Verbosity is at least 3 > > Like I said I am able to make outbound calls no issue .. I assume this would > mean that outbound I and able to register with BroadVoice? > > Any ideas? > > BRW > > > -----Original Message----- > From: Johnathan Corgan [mailto:[EMAIL PROTECTED] > Sent: Tuesday, April 12, 2005 6:42 PM > To: [EMAIL PROTECTED]; Asterisk Users Mailing List - Non-Commercial > Discussion > Subject: Re: [Asterisk-Users] BroadVoice Inbound Not working .. > > Brian Watters wrote: > > > Ok .. It appears we have outbound calls working well via our SIP trunk > > and BroadVoice .. However inbound just plain does not work, What > > happens is when you call our BroadVoice number it tells you the person > > you are calling is not available .. Never makes it to our Asterisk? .. > > Any ideas where to look and or what to tweak? > > If the incoming SIP connection really isn't making it to your Asterisk > (verify with 'sip debug' command on console), it is likely because BV > doesn't know where to connect to. > > * accomplishes this by a process called "registration." In your sip.conf, > near the top in the [general] section, you should have a line that starts > out: > > register => > > If this is there, can you send it (and change the password to something > innocuous?) > > If this line is there, you can see whether it succeeded by typing 'sip show > registry' at the console. > > If that shows the state of registered, and your sip debug output shows an in > coming connection request from BV, then there are further steps for > debugging, but start with the above. > > -Johnathan > > > _______________________________________________ > Asterisk-Users mailing list > [email protected] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
