Many thanks for your help: Details are as follows:
================ Show voice dsp ===================== delta#show voice dsp
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT
==== === == ======== ======= ===== ======= === == ========= == ===== ============
delta#
================ Show ver =======================
delta#show ver
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3620-J1S3-M), Version 12.3(13a), RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Tue 26-Apr-05 09:12 by ssearch
Image text-base: 0x60008B00, data-base: 0x619C0000
ROM: System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
ROM: 3600 Software (C3620-J1S3-M), Version 12.3(13a), RELEASE SOFTWARE (fc2)
delta uptime is 2 hours, 57 minutes System returned to ROM by power-on System image file is "flash:c3620-j1s3-mz.123-13a.bin"
cisco 3620 (R4700) processor (revision 0x81) with 58368K/7168K bytes of memory.
Processor board ID 24364331
R4700 CPU at 80MHz, Implementation 33, Rev 1.0
Channelized E1, Version 1.0.
Bridging software.
X.25 software, Version 3.0.0.
TN3270 Emulation software.
Primary Rate ISDN software, Version 1.1.
2 Ethernet/IEEE 802.3 interface(s)
32 Serial network interface(s)
2 Channelized E1/PRI port(s)
DRAM configuration is 32 bits wide with parity disabled.
29K bytes of non-volatile configuration memory.
24576K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
delta#
================= Show inte desc =======================
delta#show inte desc
Interface Status Protocol Description
Et0/0 up up connected to CorporateNetwork
Se0/0:0 admin down down
Et0/1 admin down down
Se1/0:0 down down
Se1/0:1 down down
Se1/0:2 down down
Se1/0:3 down down
Se1/0:4 down down
Se1/0:5 down down
Se1/0:6 down down
Se1/0:7 down down
Se1/0:8 down down
Se1/0:9 down down
Se1/0:10 down down
Se1/0:11 down down
Se1/0:12 down down
Se1/0:13 down down
Se1/0:14 down down
Se1/0:15 down down
Se1/0:16 down down
Se1/0:17 down down
Se1/0:18 down down
Se1/0:19 down down
Se1/0:20 down down
Se1/0:21 down down
Se1/0:22 down down
Se1/0:23 down down
Se1/0:24 down down
Se1/0:25 down down
Se1/0:26 down down
Se1/0:27 down down
Se1/0:28 down down
Se1/0:29 down down
Se1/0:30 down down
Di0 up up
delta#
============= show running-config ==================== delta#show running-config Building configuration...
Current configuration : 1996 bytes ! version 12.3 service timestamps debug uptime service timestamps log uptime service password-encryption ! hostname delta ! boot-start-marker boot-end-marker ! enable secret 5 ######################### enable password 7 ########################## ! clock timezone GMT 0 no aaa new-model ip subnet-zero no ip routing ! ! ip name-server 192.168.1.10 ! no ip cef ip dhcp-server 192.168.1.10 isdn switch-type primary-net5 isdn voice-call-failure 0 ! ! ! voice class codec 3 codec preference 1 g711alaw codec preference 2 g711ulaw ! ! ! ! ! ! ! ! ! username admin privilege 15 password 7 ################## username jmls privilege 15 password 7 ################### ! ! controller E1 0/0 channel-group 0 timeslots 1-31 ! controller E1 1/0 pri-group timeslots 1-31 ! ! ! interface Ethernet0/0 description connected to CorporateNetwork ip address 192.168.1.11 255.255.255.0 no ip route-cache no ip mroute-cache half-duplex no mop enabled ! interface Serial0/0:0 no ip address no ip route-cache shutdown ! interface Ethernet0/1 no ip address no ip route-cache no ip mroute-cache shutdown half-duplex ! interface Serial1/0:15 no ip address no ip route-cache isdn switch-type primary-net5 no cdp enable ! interface Dialer0 no ip address ! no ip http server ip classless ! ! dialer-list 1 protocol ip permit dialer-list 1 protocol ipx permit ! ! ! ! ! dial-peer voice 1000 voip application session destination-pattern .T voice-class codec 3 session protocol sipv2 session target ipv4:90.0.0.33 session transport udp dtmf-relay rtp-nte ! dial-peer voice 100 pots application session max-conn 30 destination-pattern 0.......... translate-outgoing called 1 no digit-strip direct-inward-dial forward-digits all ! sip-ua retry invite 4 retry response 3 retry bye 2 retry cancel 2 sip-server ipv4:192.168.1.20 ! ! telephony-service ! ! line con 0 exec-timeout 0 0 password 7 ############### login line aux 0 line vty 0 4 password 7 #################### login ! ! end
delta#
Julian.
barney wrote:
Wow :-) . Ok, try to send whole running-config from your router and also send me output from commands: "show ver", "show voice dsp" and "show inte desc"
-b
----- Original Message ----- From: "Asterisk" <[EMAIL PROTECTED]>
To: "Asterisk Users Mailing List - Non-Commercial Discussion" <[email protected]>
Sent: Tuesday, May 17, 2005 12:23 PM
Subject: Re: [Asterisk-Users] Re: cisco 3620 setup (newbie cisco alert)
The "^" marker appeared under the "o" in "port", the email changed the position :(
So it seems as if the "port" command in missing.
delta(config-dial-peer)#port ? % Unrecognized command delta(config-dial-peer)#port
Julian
barney wrote:
_______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
