On Tue, 24 May 2005, Peter Svensson wrote:
On Tue, 24 May 2005, Remco Barende wrote:
I'm trying to setup a Wildcard TE110P with a PRI in The Netherlands.
I get a Red Alarm on the line.
Is there any way of debugging this? I've tried some configs that should
work but without success. Is there any way of telling if the cabling is
correct or what else the problem could be?
Have you configured the card to E1 and not T1? Red alarm is usually a loss
of carrier (or close enough most of the time). I.e. you are not seeing
incoming signals from the remote end.
Yes I have configured it to E1. I'm pretty sure the line is working ok, if
i connect the pstn line again to the hdsl desktop unit which in turn
connects to the old pbx there are no warnings on the hdsl desktop thingy.
Check thatthe card is set to E1, check the cabling and check that the
remote end is up.
I don't know if the cabling is correct, I used the existing cabling.
Thanks!
Remco
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
