This is what I have:
# Span 1: WCTDM/0 "Wildcard TDM400P REV H Board 1"
fxoks=1
fxoks=2
fxoks=3
# channel 4, WCTDM, inactive.
# Span 2: WCFXO/0 "Wildcard X101P Board 1"
fxsks=5
# Global data
loadzone = us
defaultzone = us
Which from your response appears correct.
Could it have confused the cards? If I swap them in the config might that
work?
Angus
----- Original Message -----
From: "Ralf Schlatterbeck" <[EMAIL PROTECTED]>
To: "Asterisk Users Mailing List - Non-Commercial Discussion"
<[email protected]>
Sent: Saturday, June 04, 2005 8:30 PM
Subject: Re: [Asterisk-Users] X100P installed OK,after added TDM400P
Asterisk would no longer start
On Sat, Jun 04, 2005 at 07:57:36PM +0100, Angus Comber wrote:
But I have just added a TDM400P card (specifically a TDM30B) and now
problems.
Found a Wildcard TDM: Wildcard TDM400 R Rev H (4 module)
wcfxs
Running ztcfg: ZT_CHANCONFIG failed on channel 1: Invalid argument (22)
Did
you forget that FXS interfaces are configured with FXO signalling and
that
FXO interfaces use FXS signalling
[FAILED]
You have FXS modules (to attach analogue phones), the driver already
tells you, you probably have configured wrong signalling in
/etc/zaptel.conf, for an FXS module it should have somthing like:
fxoks=1-8
(the numbers depend on how many modules you have, so you should have 1-3
I guess)
Ralf
--
Ralf Schlatterbeck
email: [EMAIL PROTECTED] FAX: +43/2243/26465/23
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
