I am not sure if my problem falls into this category. I have a linksys SPA3102 on Trixbox 1.2. If I call in on the PSTN which the SPA3102 is connected to and hangup during the Trixbox Greeting. It does not detect the hangup / Disconnect tone and the line stays open but in my case the disconnected call goes to my voice mail extension which then records about 3 mins of the fast disconnected tone before the mail box is full (about 3 mins) and then finally disconnects. other times it just stays connected for about a minute and a half before disconnecting. I am not sure if the problem is with either my SPA3102 or the Trixbox but one of them is not detecting this tone. If I enable Detect PSTN Long Silence on the SPA3102 then I get disconnect when I get placed on hold by anyone without some kind of hold music or beeps. I have played around with the duration of the silence but it ends up defeating the cause as i have to set it to a high number to be effective. Does anyone have a solutions to this problem?
On 10/19/06, Henry.L.Coleman <[EMAIL PROTECTED]> wrote:
I have the same problem on a FX line while the other 3 normal lines are fine I have tried everything. The only way we are ever going to solve this problem is to detect the off-hook warning tone. Here is the spec for N/America : 1400 Hz, 2060 Hz, 2450 Hz, and 2600 Hz, at a cadence of 0.1s on, 0.1s off. If anyone can code * to hang up a zap channel on this tone I would be most grateful (and so would a lot of other people) (This is definately a three beer bounty) Henry L.Coleman CEO . *VoIP-PBX* 1-866-415-5355 Toronto Ontario Canada >>>> On Thu, Oct 19, 2006 at 2:57 PM, in message > <[EMAIL PROTECTED]>, > <[EMAIL PROTECTED]> wrote: >> Interesting, thanks. That's more than our Aliant rep was able to > tell us. >> He thinks that supervised disconnect is not available on home phone > lines. He >> does think it available on business lines though. I'll have to go to > >> someone's house where there's high speed and give this a shot again. > > I also have this problem with my Asterisk setup (occasional failure to > hang up the line). I blamed it on the crappy Zaptel clone card I have, > but it sounds like it might be due to another reason. > > How can I forcibly hangup the channel from within the CLI? > > - Julian > > > -- > -- Julian C. Dunn, P.Eng. <[EMAIL PROTECTED]> > -- Platform Administrator * CBC.ca Production & Operations > -- Office: 2C310-J * Tel.: (416) 205-3311 x6988 > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
