Would that not dial twice if both Zap and Iax are available?
-----Original Message-----
From: philip mullis [mailto:[EMAIL PROTECTED]
Sent: July 20, 2007 9:45 AM
To: Julian Sulatycki
Cc: [email protected]
Subject: Re: [on-asterisk] Using an outboud route with Dial()
Dont know if this is working in the new version but you could do
something super simple like
exten _X.,1,Dial(Zap/g1/${EXTEN})
exten _X.,2,Dial(IAX2/yadaa/${EXTEN})
On Fri, 2007-07-20 at 09:39 -0400, Julian Sulatycki wrote:
> I'm not sure if this is Trixbox specific but how would I use the
> Asterisk Dial command to make an outgoing call using an outbound route
> instead of a trunk directly?
>
> I'm currently using: Dial(ZAP/g0/numbertocall). If Zap is busy I would
> like it to fail over to an IAX connection. This behavior is currently
> working on an outbound route but I have not found any documentation on
> how to call tell Dial() to use the route.
>
> Any suggestions?
>
>
>
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
