I have a new installation of Trixbox... After a period of time, when I call my single inbound VoIP Trunk, it just clicks and fast busy signals. It is supposed to go to the Automated Attendant. If I go into FreePBX and just re-save/apply the same Inbound Route in FreePBX, it seems to start working fine again. Then after a while, it stops working. I can make outbound calls without an issue, it still just clicks for inbound.
Has anyone run into this... it seems intermittent and I have no as to if it is IVR, Inbound Route or a Trunk issue... or where to start to debug it. Any suggestions? Regards, Chuck --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
