Jim Van Meggelen wrote:
Extension 's' will only work if the call arrives without an extension.
Your ATA is passing that extension.
I did the initial setup of this device in April/May; and then could not
get back to it until now. I searched through the SPA3102 config pages;
under "Admin - Advanced - PSTN line", I found a section called "Dialplans".
Dialplans 1-7 have "(xx.)"; whereas 8 has "S0<:[email protected]>".
Thinking the 8th position had something to do with 5 rings; I exchanged
values in position 1 & 8. Now asterisk answers after 3rd ring; but
nothing appears in console with until I enter any extension number.
When you call, make sure you have the asterisk console up, with
verbosity set to 5. You'll be able to see when the signal to asterisk
arrives.
With verbosity set to 5; nothing appears on console until after 5th
ring. After changing Dialplan settings on SPA3102 as above; I hear
dialtone after 3 rings, but nothing appears on console until after I
enter an extension number.
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
