The "S0" means end of input, so what you've effectively done is require 3 or more digits of input before routing the call to Asterisk by changing it to "xx.". If you set that to <S0:s>, it will try to reach extension 's' at the default SIP proxy, or if you entered <S0:123> it would try '123'
On the "PSTN Line" screen there is an "Answer Delay" under the section "FXO Timer Values (sec)". The default value is something like 16 seconds. North American analog ringing is 2s on, 4s off, 2s on, 4s off, etc.., and in my tests I found that it consistently captured caller ID down as low as 5 seconds in that field. You should then only be hearing 2-3 rings when calling in before asterisk picks up. To get logging from the device, you need to fill in the IP address of a syslog server (i.e. your asterisk server) on the System tab. This means that you need to have syslog configured to log messages from remote devices. Hope that helps! Cheers, spd 2009/8/16 Frank Bax <[email protected]>: > Jim Van Meggelen wrote: >> >> Extension 's' will only work if the call arrives without an extension. >> Your ATA is passing that extension. > > > I did the initial setup of this device in April/May; and then could not get > back to it until now. I searched through the SPA3102 config pages; under > "Admin - Advanced - PSTN line", I found a section called "Dialplans". > > Dialplans 1-7 have "(xx.)"; whereas 8 has "S0<:[email protected]>". > > Thinking the 8th position had something to do with 5 rings; I exchanged > values in position 1 & 8. Now asterisk answers after 3rd ring; but nothing > appears in console with until I enter any extension number. > > >> When you call, make sure you have the asterisk console up, with verbosity >> set to 5. You'll be able to see when the signal to asterisk arrives. > > With verbosity set to 5; nothing appears on console until after 5th ring. > After changing Dialplan settings on SPA3102 as above; I hear dialtone after > 3 rings, but nothing appears on console until after I enter an extension > number. > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > > -- | It ain't what you don't know that gets you into trouble. It's what | you know for sure that just ain't so. -- Mark Twain | | Network: http://www.linkedin.com/in/spditner | http://facebook.com/people/Simon-P-Ditner/776370031 | http://twitter.com/spditner --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
