Would it be possible to send me a copy of your XML file, with the appropriate fields blanked out?
-- Nabeel Jafferali X2 Networks Inc. -----Original Message----- From: Douglas Pickett [mailto:[email protected]] Sent: February-23-10 5:20 PM To: Nabeel Jafferali; [email protected] Subject: Re: [on-asterisk] Polycom line "rollover" Nabeel, I have an IP 430 on my test system, and the line keys work as you'd expect (first call to first button, a second call goes to the second line button). I would assume most of the Polycoms should work the same. Going in through the web interface to the phone, the key settings look to be "Num Line Keys" set to 2 and the "Calls Per Line" set to 1. Looking at the xml file, it has reg.1.lineKeys="2" in it. Regards, Doug. ----- Original Message ----- From: "Nabeel Jafferali" <[email protected]> To: <[email protected]> Sent: Tuesday, February 23, 2010 3:42 PM Subject: [on-asterisk] Polycom line "rollover" >I have a few Polycoms (mix of 501s, 600s, 550s), all registered to an > Asterisk box. There is only a single registration per phone, and all lines > are configured to the same registration (e.g. reg.1.lineKeys="6"). If I > set > calls per line key to 1, the 2nd concurrent call fails. If I set calls per > line key to greater than 1, the 2nd concurrent call rings to line key 1, > instead of "rolling over" and ringing to line key 2. > > > > I know I could assign multiple registrations and roll over in Asterisk, > but > Linksys phones on the same system behave as expected. > > > > Any ideas? > > > > -- > > Nabeel Jafferali > > X2 Networks Inc. > > > > --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
