Hi Group As per the WAN Failover page, I tried to configure the backup interface for PPPoE as follows. Note primary WAN is static address on eth0:
Network Tab -> Failover Interface -> eth2 user.conf PPPOEUSER="username" PPPOEPASS="password" PPPOEIF="eth2" EXT2IF="ppp0" However after doing this, it allocated ppp0 as the default route even though it was showing as EXT2IF and eth0 as EXTIF. WAN Failover would also not start with an error of ‘daemon.err wan-failover: ERROR Primary interface gateway not found, will restart on a network change.’ Any ideas? Regards Michael Knill
_______________________________________________ Astlinux-users mailing list Astlinux-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/astlinux-users Donations to support AstLinux are graciously accepted via PayPal to pay...@krisk.org.
