Yes I thought about that but it certainly seems a bit messy ☹
Back to the drawing board I guess.
Regards
Michael Knill
On 13/10/18, 6:47 am, "Lonnie Abelbeck" <li...@lonnie.abelbeck.com> wrote:
Michael,
It appears the "DEFAULTROUTE=yes" is set to the pppoe.conf in our network
script ... you don't want to be messing with that.
> Do I have any other options?
Make the PPPoE as the primary link and the other as the EXT2IF link, add
some major routing to EXT2IF link.
Lonnie
> On Oct 12, 2018, at 2:25 PM, Michael Knill
<michael.kn...@ipcsolutions.com.au> wrote:
>
> Hmm that's a pity. The scenario is that I have a site where I believe I
am having voice issues on the primary link (static IP), so I have installed
another WAN service from a known working provider (PPPoE).
> So I want to send all traffic out the primary and send the voice traffic
only out the backup. I was hoping to do this with WAN Failover with a secondary
route configured and I really don't want to configure the modem into router
mode and rely on it to do NAT.
>
> Do I have any other options?
>
> Regards
> Michael Knill
>
> On 13/10/18, 6:10 am, "Lonnie Abelbeck" <li...@lonnie.abelbeck.com> wrote:
>
> Hi Michael,
>
>> However after doing this, it allocated ppp0 as the default route even
though it was showing as EXT2IF and eth0 as EXTIF.
>
> Yes, I can see that happening.
>
> Possibly we need to edit that WiKi section.
>
https://doc.astlinux-project.org/userdoc:tt_wan_failover#pppoe_on_failover_interface
>
> For PPPoE on a failover (EXT2IF) interface, can you configure your
PPPoE modem in "router" mode where the credentials are set in the modem ? Then
the AstLinux configuration would be just like a 4G/LTE modem in "router" mode.
In such a case you would set the "WAN Failover Configuration -> External
Failover Interface:" as "Static IP" to match the subnet defined by the PPPoE
modem in "router" mode.
>
> If the failover connection is over WireGuard the extra NAT of the
PPPoE modem in "router" mode should not be an issue.
>
> Lonnie
>
>
>
>> On Oct 12, 2018, at 2:24 AM, Michael Knill
<michael.kn...@ipcsolutions.com.au> wrote:
>>
>> And the other question is what I set the WAN Failover Tab -> Connection
Type: to? DHCP?
>>
>> Regards
>> Michael Knill
>>
>> From: Michael Knill <michael.kn...@ipcsolutions.com.au>
>> Reply-To: AstLinux List <astlinux-users@lists.sourceforge.net>
>> Date: Friday, 12 October 2018 at 6:20 pm
>> To: AstLinux List <astlinux-users@lists.sourceforge.net>
>> Subject: [Astlinux-users] WAN Failover and PPPoE
>>
>> Hi Group
>>
>> As per the WAN Failover page, I tried to configure the backup interface
for PPPoE as follows. Note primary WAN is static address on eth0:
>>
>> Network Tab -> Failover Interface -> eth2
>>
>> user.conf
>> PPPOEUSER="username"
>> PPPOEPASS="password"
>> PPPOEIF="eth2"
>> EXT2IF="ppp0"
>>
>> However after doing this, it allocated ppp0 as the default route even
though it was showing as EXT2IF and eth0 as EXTIF.
>> WAN Failover would also not start with an error of ‘daemon.err
wan-failover: ERROR Primary interface gateway not found, will restart on a
network change.’
>>
>> Any ideas?
>>
>> Regards
>> Michael Knill
>> _______________________________________________
>> Astlinux-users mailing list
>> Astlinux-users@lists.sourceforge.net
>> https://lists.sourceforge.net/lists/listinfo/astlinux-users
>>
>> Donations to support AstLinux are graciously accepted via PayPal to
pay...@krisk.org.
>
>
>
> _______________________________________________
> Astlinux-users mailing list
> Astlinux-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/astlinux-users
>
> Donations to support AstLinux are graciously accepted via PayPal to
pay...@krisk.org.
>
>
> _______________________________________________
> Astlinux-users mailing list
> Astlinux-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/astlinux-users
>
> Donations to support AstLinux are graciously accepted via PayPal to
pay...@krisk.org.
_______________________________________________
Astlinux-users mailing list
Astlinux-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/astlinux-users
Donations to support AstLinux are graciously accepted via PayPal to
pay...@krisk.org.
_______________________________________________
Astlinux-users mailing list
Astlinux-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/astlinux-users
Donations to support AstLinux are graciously accepted via PayPal to
pay...@krisk.org.
