On 09/23/2014 02:16 AM, Michal Kazior wrote:
On 19 September 2014 20:28, <[email protected]> wrote:
[...]
+ /* If we are CT firmware, ask it to flush all tids on all peers on
+ * all vdevs. Normal firmware will just crash if you do this.
+ */
+ if (test_bit(ATH10K_FW_FEATURE_WMI_10X_CT, ar->fw_features))
+ ath10k_wmi_peer_flush(ar, 0xFFFFFFFF, peer_addr, 0xFFFFFFFF);
I recall you've explained this some time ago, but can you refresh my
memory, please? Is this any different from iterating over all peers
and flushing each? Or does your firmware do so extra magic that is
impossible to do with normal firmware commands?
My firmware does that iteration internally.
You could probably do that in the driver, but it would be a lot
of messages (for all vdevs, all peers, all tids)...
I was not sure if there were limits to the number
of commands you should attempt during the flush...
Thanks,
Ben
--
Ben Greear <[email protected]>
Candela Technologies Inc http://www.candelatech.com
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
