On 11/19/2015 07:35 AM, Sebastian Gottschall wrote:
Am 19.11.2015 um 16:33 schrieb Ben Greear:
On 11/19/2015 07:10 AM, Sebastian Gottschall wrote:
6.064984] ath10k_pci 0000:01:00.0: enabling device (0140 -> 0142)
[ 6.065432] ath10k_pci 0000:01:00.0: pci irq legacy interrupts 0 irq_mode 0
reset_mode 0
[ 8.448583] ath10k_pci 0000:01:00.0: unable to read from the device
[ 8.448614] ath10k_pci 0000:01:00.0: could not execute otp for board id
check: -110
[ 8.453657] ath10k_pci 0000:01:00.0: failed to get board id from otp for
qca99x0: -110
[ 8.461352] ath10k_pci 0000:01:00.0: could not probe fw (-110)
it seems that the there is some sort of problem with the otp. unfortunatly
ath10k gives also no usefull information about the reason.
this is a embedded ap148 based device (ipq8064) with QCA998X chipsets on it
What kernel, what firmware, what board.bin are you using?
plain ath10k with kernel 3.18.23. standard firmware-5 from ath10k github, same
for board.
The kernel tree below at least booted up the 4x4 NIC for me with stock upstream
firmware.
http://dmz2.candelatech.com/git/gitweb.cgi?p=linux.ath/.git;a=summary
git clone git://dmz2.candelatech.com/linux.ath
It has most of my patch-set applied...but not sure any of those patches
are really needed for basic functionality.
Thanks,
Ben
--
Ben Greear <[email protected]>
Candela Technologies Inc http://www.candelatech.com
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
