Hi Michal, thanks for your instant response. May I ask why this isn't implemented in a new firmware release? Is there a short manual, what and where I need to edit the code and how to compile it? I'm not that familiar with coding on that level. Thanks.
Best Regards, Frank -----Ursprüngliche Nachricht----- Von: Michal Kazior [mailto:[email protected]] Gesendet: Dienstag, 16. Februar 2016 15:46 An: Lindner, Frank Cc: [email protected] Betreff: Re: Bug: QCA9880 hw2.0: TX-Rate Display in Wireshark On 16 February 2016 at 15:33, Lindner, Frank <[email protected]> wrote: > Hi there, > > I'm using QCA980 hw2.0 (Compex WLE900VX5) in monitor mode. Using Linux Kernel > 4.3.3 and ath10k firmware 10.2.4.70.19-2. > When capturing 2.4 GHz WIFI operating in 802.11g (1 to 54 Mbit/s), Wireshark > displays only 1, 2, 5.5 or 11 Mbit/s as TX rate for the frames. When > capturing in parallel with Airpcap on Windows or a Ralink-based card in > monitor mode, frame TX rate is displayed correctly with 1 to 54 Mbit/s. > I also tried older firmware versions. Same issue. > Also when trying to capture with tcpdump, only up 11 Mbit/s is shown. > Is this a known issue? > Is there any fix for this? https://wireless.wiki.kernel.org/en/users/drivers/ath10k#known_bugslimitations If you don't mind dirtying your hands with some C code you can try using the following patch (it will not cleanly apply to upstream kernel but should be fairly straightforward to port): https://groups.google.com/a/chromium.org/forum/#!topic/chromium-os-checkins/YGYm6gNUnEE Michał Vorstandsvorsitzender: Dipl.-Ing. Dirk Wilhelm Aufsichtsratsvorsitzender: Dr.-Ing. Peter Hasse Handelsregister: HRB Saarbrücken Nr. 13201 Ust.ID Nr.: DE 153807627 _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
