Hi All, I have some difficulty in understanding how HT40, HT40- and HT40+ modes work. My objective is to set a particular 20 MHz channel as the primary channel when channel bonding is enabled. From what I understand, HT40- means secondary channel is below the primary, while HT40+ means secondary channel is above the primary channel. I am particularly dealing with channels 149, 153, 157 and 161.
When I set the channel to say 157, whether I use HT40+ or HT40-, the primary channel is always set to channel 161. I am inferring this because when I scan using iwlist scan, my SSID shows on Channel 161. Does ath10k not set the primary and secondary channel in this manner? If not, is there a mechanism by which I can explicitly mention which channel must be primary, and which must be secondary? Also, how is the primary channel decided for VHT80 mode? Note: I am using OpenWrt in my AP. So I set the htmode as an option in the /etc/config/wireless file. Thanks, Gaurang. _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
