Hi, is it possible to run a mesh point and an access point on the same physical interface? I have tried with a WLE900VX QCA9880, kernel 4.10 with no success.
But according to this thread http://lists.infradead.org/pipermail/ath10k/2016-September/008374.html it should be possible. iw list gives to following: #valid interface combinations: # * #{ AP, mesh point } <= 8, #{ managed } <= 1, # total <= 8, #channels <= 1, STA/AP BI must match ... So it is not a valid combination? I have tried t bring up the ap interface with iw / hostapd, after joining the mesh. When I start the second interface, rtnetlink responds with device or resource busy. thanks, Hannes _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k
