On 10/06/2017 05:00 AM, Harms, Hannes wrote:
Hi,
is it possible to run a mesh point and an access
point on the same physical interface?
I have tried with a WLE900VX QCA9880, kernel 4.10 with no success.
But according to this thread
http://lists.infradead.org/pipermail/ath10k/2016-September/008374.html
it should be possible.
iw list gives to following:
#valid interface combinations:
# * #{ AP, mesh point } <= 8, #{ managed } <= 1,
# total <= 8, #channels <= 1, STA/AP BI must match ...
So it is not a valid combination?
I have tried t bring up the ap interface with iw / hostapd,
after joining the mesh.
When I start the second interface, rtnetlink responds with
device or resource busy.
IBSS + AP works on the CT firmware/driver, at least,
but our CT 10.1 (988x) firmware does not support MESH at this point.
I think I had to modify the driver to relax the valid combinations check,
and possibly the stock firmware cannot handle that.
Maybe someday we'll support MESH on 988x, but to date, there has not been
a lot of interest...
http://www.candelatech.com/ath10k.php
Thanks,
Ben
--
Ben Greear <[email protected]>
Candela Technologies Inc http://www.candelatech.com
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
