On 10/19/2017 07:42 AM, Lindner, Frank wrote:
Hi,
I want to use Compex WLE1216-V2 20 modules. This is the 2.4 GHz module of the
QCA9984. It seems, that I need a board.bin instead of typical board-2.bn for
QCA9984 5 GHz version.
The card is requesting “bus=pci,bmi-chip-id=0,bmi-board-id=30”. I found a
board.bin file, that’s get loaded by the driver, but this pushed 5 GHz channels
to the card, which might not work. Even than I can not set to 2.4 GHz channels,
cause iw phy info it tells me only 5 GHz channel support.
Where can I download the correct board.bin and, if needed, the firmware-x.bin
file? Any ideas?
Thanks a lot in advance.
At least for the 5Ghz version of that card, you need to get a special board.bin
file from Compex.
And, I'm curious what use you get out of a 9984 NIC on 2.4Ghz? Are you running
VHT on 2.4?
Thanks,
Ben
--
Ben Greear <[email protected]>
Candela Technologies Inc http://www.candelatech.com
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
