On 10/26/2017 04:20 AM, KAVITA MATHUR wrote:
Hi,
In my AP , there are two radios, one ath9k based module WLE200NX and second
ath10k based
WLE600VX.
I configured both the radios as AP in IEEE 802.11a 40 MHz HT mode and performed
throughput test.
Measured throughput with ath9k is 164Mbps while with ath10k it is 137Mbps. I
could not
understand the reason of this drop(27 Mbps)?
My test setup was inside RF-Shield. There was no interference and system was
associated
at 300Mbps in both cases.
ath10k driver was taken from ath10k git and firmware version is
firmware-5.bin_10.2.4.70.66.
ath9k drives was taken from stable backport release backport-4.4.2-1.
kernel version : 3.12
openwrt version : Chaos Calmer 15.05.0
Please suggest me how can I increase the throughput of my AP.
Does it work any better with different firmware/software, or is ath10k just
always slower
for you?
How much attenuation are you using?
Thanks,
Ben
Thanks & Regards,
कविता माथुर Kavita Mathur
वरिष्ठ अनुसंधान अभियंता Senior Research Engineer
सी-डॉट C-DOT
इलैक्ट्रॉनिक्स सिटी फेज़ I Electronics City Phase I
होसूर रोड, बेंगलूरु Hosur Road, Bengaluru – 560100
फोन Ph 080-28529896
Disclaimer:
----------
This email and any files transmitted with it
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
--
Ben Greear <[email protected]>
Candela Technologies Inc http://www.candelatech.com
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
