Sujith, >> Does this mean if I do a git-pull now I should get this? >> Or is there some delay? >> > > You should get it, since the commit is in wireles-testing. > I got Already up-to-date so you must have updated a few days ago before my last go.
The wireless link seems to be a lot more stable and I have not had a lockup since. However, I still have the problem where my router shows. IP Address Mode Rate (Mbps) Signal (%) 0.0.0.0 802.11g 130 62 Now I thought this might just have been a router issue so I upgraded my firmware(glutton for punishment:). The update went well I am now at firmware Version: 1.21 Hardware Version: A3 Product Page: DIR-655 (no-securespot version) Again this seems to have improved things a lot. But I am still left with the problem above. Given that the wireless says it is set up for 11n Wireless Enabled 802.11 Mode : Mixed 802.11n and 802.11g Channel Width : 40MHz Channel : 8 Secondary Channel : 4 WISH : Active Wi-Fi Protected Setup : Enabled/Configured I do not understand why it says 11g Is there any way to show the actual MBs from the host side? I am in the process of setting up iperf. Thanks, Brian _______________________________________________ ath9k-devel mailing list [email protected] https://lists.ath9k.org/mailman/listinfo/ath9k-devel
