On Mon, Dec 15, 2008 at 07:12:29AM -0800, Brian wrote: > > > Sujith, > >> Does this mean if I do a git-pull now I should get this? > >> Or is there some delay? > >> > > > > You should get it, since the commit is in wireles-testing. > > > I got Already up-to-date so you must have updated a few days ago before > my last go. > > The wireless link seems to be a lot more stable and I have not had a > lockup since. > > However, I still have the problem where my router shows. > > IP Address Mode Rate (Mbps) Signal (%) > 0.0.0.0 802.11g 130 62 > > Now I thought this might just have been a router issue so I upgraded my > firmware(glutton for punishment:). The update went well I am now at > firmware Version: 1.21 > Hardware Version: A3 > Product Page: DIR-655 > (no-securespot version) > > Again this seems to have improved things a lot. > But I am still left with the problem above. > Given that the wireless says it is set up for 11n > > Wireless Enabled > 802.11 Mode : Mixed 802.11n and 802.11g > Channel Width : 40MHz > Channel : 8 > Secondary Channel : 4 > WISH : Active > Wi-Fi Protected Setup : Enabled/Configured > > I do not understand why it says 11g
It means it will support stations that use either 11n or 11g. If you have a station that supports 11n it will use 11n rates and aggregation. If you use an 11g STA it will stick to 11g for communication only with that STA. > Is there any way to show the actual MBs from the host side? New patch for nl80211/cfg80211/iw has support to see what last TX rate was being used, even for 11n rates. Check the lists for that. Luis _______________________________________________ ath9k-devel mailing list [email protected] https://lists.ath9k.org/mailman/listinfo/ath9k-devel
