I believe CONFIG_ATH_DEBUG is enabled, but I'll double check again. Attached is the hostapd.conf we're using. Right now the only logs we see are what's in syslog or dmesg, but I'd be more than happy to enable whatever I can. Just need to know what to configure.
Thus far everytime we've had an issue with clients unable to connect, a restart of hostapd fixed it. Strangely, the clients were able to see the SSID broadcast, but failed immediately upon a connection attempt. The problem also seems to be all or none. Once one client looses connection, they all do until hostapd is restarted or the device is power cycled. On Wed, Apr 30, 2014 at 1:40 PM, Oleksij Rempel <li...@rempel-privat.de> wrote: > Am 30.04.2014 22:16, schrieb Oleksij Rempel: >> Am 30.04.2014 20:59, schrieb Aaron Hamilton: >>> Unfortunately our units are in another state, so we're unable to make >>> the electrical connections. If the UART is RS-232, we might be able to >>> modify some locally - but it'll be a rather difficult challenge. >> >> It is TTL level, 3,3 Volt. >> >>> Not >>> to mention, we see a great deal of issues in the field, but can't >>> duplicate them here. >> >> Did you tried to grab hostpad log to so what kind of connections do you >> have? What is your hostapd config? >> >>> On the firmware, I'm pulling down io_clean-2014.04.29 right now. I'm >>> assuming this is what I should be using? >> >> You can use it, but these changes should make sense only if you can get >> oops log from firmware. Or at least FW panic report from dmesg. >> >> Theoretically this change set should not affect stability. >> >>> Are there any other options for debugging aside from the UART? We're >>> really in a bind and feel like the only work around is to setup a task >>> to restart hostapd every hour. >> >> Hmm.. restarting hostpad should not affect firmware. Is it really >> working for you? > > Make sure you have CONFIG_ATH_DEBUG enabled. May be we can get some > interesting information. For example WMI timeouts are printed with > ath_dbg which is disable without CONFIG_ATH_DEBUG. > > -- > Regards, > Oleksij >
hostapd.conf
Description: Binary data
_______________________________________________ ath9k-devel mailing list ath9k-devel@lists.ath9k.org https://lists.ath9k.org/mailman/listinfo/ath9k-devel
