Hello Everyone, I currently use SB3 -> (OPT OUT) -> Arcam AVR-350 -> Speaker setup. Works pretty good and I do not need to worry about anything.
I am thinking of upgrading my 2ch setup and I am thinking to get TP with decent power amps that can drive speakers that may deep below 4ohm load (Classe, Bryston, McIntosh etc). I read wiki article on connecting TP directly into power amp and potential issues that come with it. The biggest issue that I am worried about is that TP going off by itself with LOUD volume when TP is connected to power amp directly. Is there a way to guard this potential issue? With SB3, it happened twice but since SB3 was connected to the receiver and the receiver was off, no harm was done. Thank you for your advise. -- ReferenceLover ------------------------------------------------------------------------ ReferenceLover's Profile: http://forums.slimdevices.com/member.php?userid=9871 View this thread: http://forums.slimdevices.com/showthread.php?t=38218 _______________________________________________ audiophiles mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/audiophiles
