Hello, I built AVaRICE 2.13 from source and am trying to debug an xmega16d4 using an AVR Dragon. I first upgraded the firmware on the Dragon board to 7.23 (I think - I'll need to double check that), using a friends Windows system.
I'm running the command as "avarice -g -X", but it fails with the following output: AVaRICE version 2.13, Oct 18 2015 20:56:43 JTAG config starting. Found a device: AVRDRAGON Serial number: 00:a2:00:06:06:5f set paramater command failed: Unknwon response code 0xae Failed to activate PDI debugging protocol It does not matter if the Dragon is connected to the target board or not, same error. It also seems like the Dragon is power cycling when the avarice command is executed (both LEDs go out, then the larger one comes up Orange, then goes Red and then the smaller Green LED blinks and stays lit). My system is running Ubuntu 15.04. Thank you in advance for any help with this. I'm new to avarice, so I may just be doing something wrong. Best regards, Element Green
------------------------------------------------------------------------------
_______________________________________________ avarice-user mailing list avarice-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/avarice-user
