On Fri, 02 Aug 2013 21:01:45 -0400 Ormund Williams <[email protected]> wrote:
> On Sat, 2013-08-03 at 02:37 +0200, YuGiOhJCJ Mailing-List wrote: > > I am wondering if I downgrade my avrdude ( to a version before 5.11 ), do > > you think my old firmware will be compatible with this old version of > > avrdude ? > > > That's another way to go, at long as it supports tiny2313. > > Regards. > > -- > Ormund > > > _______________________________________________ > AVR-chat mailing list > [email protected] > https://lists.nongnu.org/mailman/listinfo/avr-chat Nice I think I found an old avrdude version for my old programmer firmware: avrdude 5.2. $ sudo avrdude -v -B 50 -p t2313 -c usbasp -U flash:w:main.hex avrdude: Version 5.2, compiled on Aug 3 2013 at 04:39:58 Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/ System wide configuration file is "/usr/etc/avrdude.conf" User configuration file is "/home/spierre/.avrduderc" User configuration file does not exist or is not a regular file, skipping Using Port : /dev/parport0 Using Programmer : usbasp Setting bit clk period: 50.0 AVR Part : ATtiny2313 Chip Erase delay : 9000 us PAGEL : PD4 BS2 : PD6 RESET disposition : possible i/o RETRY pulse : SCK serial program mode : yes parallel program mode : yes Timeout : 200 StabDelay : 100 CmdexeDelay : 25 SyncLoops : 32 ByteDelay : 0 PollIndex : 3 PollValue : 0x53 Memory Detail : Block Poll Page Polled Memory Type Mode Delay Size Indx Paged Size Size #Pages MinW MaxW ReadBack ----------- ---- ----- ----- ---- ------ ------ ---- ------ ----- ----- --------- eeprom 65 6 4 0 no 128 4 0 4000 4500 0xff 0xff flash 65 6 32 0 yes 2048 32 64 4500 4500 0xff 0xff signature 0 0 0 0 no 3 0 0 0 0 0x00 0x00 lock 0 0 0 0 no 1 0 0 9000 9000 0x00 0x00 lfuse 0 0 0 0 no 1 0 0 9000 9000 0x00 0x00 hfuse 0 0 0 0 no 1 0 0 9000 9000 0x00 0x00 efuse 0 0 0 0 no 1 0 0 9000 9000 0x00 0x00 calibration 0 0 0 0 no 2 0 0 0 0 0x00 0x00 Programmer Type : usbasp Description : USBasp, http://www.fischl.de/usbasp/ avrdude: error: programm enable: target doesn't answer. 1 avrdude: AVR device initialized and ready to accept instructions Reading | ################################################## | 100% 0.00s avrdude: Device signature = 0x000000 avrdude: Yikes! Invalid device signature. Double check connections and try again, or use -F to override this check. avrdude done. Thank you. But as you can see I got some errors. Do you see the problem ? _______________________________________________ AVR-chat mailing list [email protected] https://lists.nongnu.org/mailman/listinfo/avr-chat
