Bye Jesse.
you'll be back ;) On Wed, Feb 18, 2009 at 10:50 PM, Jesse Foltz <[email protected]> wrote: > > So far so good with the frustum clipping (I'm rendering really close > to a large plane). Thats the main reason I switched to Away last > summer. I really needed scene layering to make what I wanted to do > feasible and I was just hitting too many weird snags. > > On Feb 18, 5:28 pm, Peter Kapelyan <[email protected]> wrote: > > You can miss correct z sorting and frustum clipping that actually works, > > when you need it :P > > > > > > > > > > > > On Wed, Feb 18, 2009 at 5:06 PM, Jesse Foltz <[email protected]> wrote: > > > > > ohh I guess useOwnContainer is the same thing well, I'll have to think > > > of something else to miss. > > > > > Jesse > > > > > On Feb 18, 4:34 pm, Jesse Foltz <[email protected]> wrote: > > > > Never mind I've switched back to Papervision and a lot of my problems > > > > were solved (only really took 2 hours). I will miss owncanvas. > > > > > > bye, > > > > Jesse > > > > > > On Feb 17, 5:58 pm, Jesse Foltz <[email protected]> wrote: > > > > > > > Ok this is a simple reflection faking class with a shadow. It > works > > > > > fine until I try and apply the MovieMaterial textures to the > planes. > > > > > > > Here is my code: > > > > > > >http://pastebin.com/m6645922c > > > > > > > I have a class that extends ObjectContainer3D and adds 3 planes to > > > > > itself. The Class takes in a Sprite that is supposed to be applied > to > > > > > the via a MovieMaterial to the planes. The problem is when it runs > > > > > the planes are invisible. If I comment out likes 50, 60 and 72 I > can > > > > > see the planes but when I uncomment the lines they disappear. If I > > > > > right click and show redraw regions I can see it rendering where > the > > > > > plate would be moving but it's blank. > > > > > > > here is a simple example of it not working: > > > > > > >http://pastebin.com/m3f063386 > > > > > > > if you run the example you will see and circle spinning > > > > > right click and show redraw regions and you will see the invisible > > > > > stuff > > > > > > > if you comment out the lines 50, 60 and 72 you will see the planes. > > > > > > > Any advice am I missing something fundamental? > > > > -- > > ___________________ > > > > Actionscript 3.0 Flash 3D Graphics Engine > > > > HTTP://AWAY3D.COM > -- Rob Bateman Flash Development & Consultancy [email protected] www.infiniteturtles.co.uk www.away3d.com
