2010/6/22 Fabrizio Regalli <[email protected]>: > Ok, I put "options b43 pio=0 qos=0" in /etc/modprobe.d/b43.conf > And now the message is changed: > > > ... > [ 745.708045] b43-phy1: Loading firmware version 410.2160 (2007-05-26 > 15:32:10) > [ 745.724051] b43-phy1 debug: Chip initialized > [ 745.724189] b43-phy1 debug: 32-bit DMA initialized > [ 745.724198] b43-phy1 debug: QoS disabled > [ 745.744374] b43-phy1 debug: Wireless interface started > [ 745.768105] b43-phy1 debug: Adding Interface type 2 > [ 745.796352] ADDRCONF(NETDEV_UP): wlan0: link is not ready > [ 748.160267] wlan0: authenticate with 00:18:4d:2e:85:4a (try 1) > [ 748.161313] wlan0: authenticated > [ 748.161425] wlan0: associate with 00:18:4d:2e:85:4a (try 1) > [ 748.162831] wlan0: RX AssocResp from 00:18:4d:2e:85:4a (capab=0x431 > status=0 aid=1) > [ 748.162835] wlan0: associated > [ 748.163348] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready > [ 748.168313] wlan0: deauthenticating from 00:18:4d:2e:85:4a by local > choice (reason=3) > [ 748.168466] cfg80211: Calling CRDA to update world regulatory domain > [ 749.496214] wlan0: authenticate with 00:18:4d:2e:85:4a (try 1) > [ 749.497126] wlan0: authenticated > [ 749.497240] wlan0: associate with 00:18:4d:2e:85:4a (try 1) > [ 749.498655] wlan0: RX AssocResp from 00:18:4d:2e:85:4a (capab=0x431 > status=0 aid=1) > [ 749.498659] wlan0: associated > [ 749.504316] wlan0: deauthenticating from 00:18:4d:2e:85:4a by local > choice (reason=3) > [ 749.504523] cfg80211: Calling CRDA to update world regulatory domain > > > But unfortunately does not work. > > I can obtain just the ip address: > > # ifconfig wlan0 |grep inet > inet addr:192.168.0.100 > > but iwconfig show me there isn't any access point associeted: > > wlan0 IEEE 802.11bg ESSID:off/any > Mode:Managed Frequency:2.472 GHz Access Point: Not-Associated > Tx-Power=20 dBm > Retry long limit:7 RTS thr:off Fragment thr:off > Encryption key:off > Power Management:off > >
Did you shut down NetworkManager? Also, why are you disabling QoS? Unless you are using OpenFWWF, QoS shouldn't need to be disabled. (BTW, please always CC the list / use Reply to All. Otherwise others on the list can't follow this thread.) > Thanks again. > > > 2010/6/20 Gábor Stefanik <[email protected]> >> >> On Sun, Jun 20, 2010 at 2:04 PM, Fabrizio Regalli <[email protected]> >> wrote: >> > I'm trying with an oldest firmware revision but unfortunately, nothing >> > changed. >> > >> > debiancasa:/home/rizla# dmesg |grep b43 >> > [ 2.054445] b43-pci-bridge 0000:04:05.0: PCI INT A -> GSI 17 (level, >> > low) >> > -> IRQ 17 >> > [ 8.338798] b43-phy0: Broadcom 4318 WLAN found (core revision 9) >> > [ 8.380033] b43-phy0 debug: Found PHY: Analog 3, Type 2, Revision 7 >> > [ 8.380054] b43-phy0 debug: Found Radio: Manuf 0x17F, Version 0x2050, >> > Revision 8 >> > [ 8.577430] Registered led device: b43-phy0::tx >> > [ 8.577443] Registered led device: b43-phy0::rx >> > [ 8.577455] Registered led device: b43-phy0::assoc >> > [ 8.577470] Registered led device: b43-phy0::radio >> > [ 10.844287] b43 ssb0:0: firmware: requesting b43/ucode5.fw >> > [ 10.924217] b43 ssb0:0: firmware: requesting b43/pcm5.fw >> > [ 10.940552] b43 ssb0:0: firmware: requesting b43/b0g0initvals5.fw >> > [ 10.966269] b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw >> > [ 11.084276] b43-phy0: Loading firmware version 410.2160 (2007-05-26 >> > 15:32:10) >> > [ 11.104055] b43-phy0 debug: Chip initialized >> > [ 11.104096] b43-phy0 debug: PIO initialized >> >> Why are you using PIO for a BCM4318? AFAIK the DMA bug only affects >> BCM4312. >> >> > [ 11.104106] b43-phy0 debug: QoS disabled >> > [ 11.124366] b43-phy0 debug: Wireless interface started >> > [ 11.148853] b43-phy0 debug: Adding Interface type 2 >> > [ 660.376274] b43-phy0 debug: Removing Interface type 2 >> > [ 660.376359] b43-phy0 debug: Wireless interface stopped >> > [ 667.296079] b43-phy0: Loading firmware version 410.2160 (2007-05-26 >> > 15:32:10) >> > [ 667.312082] b43-phy0 debug: Chip initialized >> > [ 667.312122] b43-phy0 debug: PIO initialized >> > [ 667.312132] b43-phy0 debug: QoS disabled >> > [ 667.333144] b43-phy0 debug: Wireless interface started >> > [ 667.356357] b43-phy0 debug: Adding Interface type 2 >> > [ 667.472274] b43-phy0 debug: Removing Interface type 2 >> > [ 667.472356] b43-phy0 debug: Wireless interface stopped >> > [ 669.584280] b43-phy0: Loading firmware version 410.2160 (2007-05-26 >> > 15:32:10) >> > [ 669.600093] b43-phy0 debug: Chip initialized >> > [ 669.600134] b43-phy0 debug: PIO initialized >> > [ 669.600143] b43-phy0 debug: QoS disabled >> > [ 669.620645] b43-phy0 debug: Wireless interface started >> > [ 669.644096] b43-phy0 debug: Adding Interface type 2 >> > >> > and in /var/log/messages a lot of this messages: >> > >> > [ 1022.268919] wlan0: RX AssocResp from 00:18:4d:2e:85:4a (capab=0x431 >> > status=0 aid=1) >> > [ 1022.268923] wlan0: associated >> > [ 1022.269690] wlan0: deauthenticating from 00:18:4d:2e:85:4a by local >> > choice (reason=3) >> > [ 1022.269826] cfg80211: Calling CRDA to update world regulatory domain >> > [ 1023.600719] wlan0: authenticate with 00:18:4d:2e:85:4a (try 1) >> > [ 1023.664562] wlan0: authenticated >> > [ 1023.664687] wlan0: associate with 00:18:4d:2e:85:4a (try 1) >> > [ 1023.864521] wlan0: associate with 00:18:4d:2e:85:4a (try 2) >> > [ 1024.064534] wlan0: associate with 00:18:4d:2e:85:4a (try 3) >> > [ 1024.264024] wlan0: association with 00:18:4d:2e:85:4a timed out >> > [ 1034.841535] wlan0: authenticate with 00:18:4d:2e:85:4a (try 1) >> > [ 1035.040024] wlan0: authenticate with 00:18:4d:2e:85:4a (try 2) >> > [ 1035.240023] wlan0: authenticate with 00:18:4d:2e:85:4a (try 3) >> > [ 1035.440035] wlan0: authentication with 00:18:4d:2e:85:4a timed out >> > >> > >> > >> > >> > >> > 2010/6/1 Martino Salvetti <[email protected]> >> >> >> >> Also me... I sent a message about this problem but it was blocked. >> >> I have this problem olny with multi-AP networks, in dmesg I can see >> >> that >> >> it continue to changes the AP until they ends to responds. (At my home, >> >> with >> >> a digicom ADSL router, the wifi works) >> >> Martino >> >> >> >> 2010/6/1 William Bourque <[email protected]> >> >>> >> >>> Just saying, I have a similar problem... I tried to post twice about >> >>> it >> >>> on the list since 2 weeks but the mails keep getting moderated (and >> >>> never unmoderated) because of "suspicious content". >> >>> >> >>> - William >> >>> >> >>> _______________________________________________ >> >>> b43-dev mailing list >> >>> [email protected] >> >>> http://lists.infradead.org/mailman/listinfo/b43-dev >> >> >> >> >> >> >> >> -- >> >> Remember: with great power comes great current squared times >> >> resistance. >> >> >> >> _______________________________________________ >> >> b43-dev mailing list >> >> [email protected] >> >> http://lists.infradead.org/mailman/listinfo/b43-dev >> >> >> > >> > >> > _______________________________________________ >> > b43-dev mailing list >> > [email protected] >> > http://lists.infradead.org/mailman/listinfo/b43-dev >> > >> > >> >> >> >> -- >> Vista: [V]iruses, [I]ntruders, [S]pyware, [T]rojans and [A]dware. :-) > > -- Vista: [V]iruses, [I]ntruders, [S]pyware, [T]rojans and [A]dware. :-) _______________________________________________ b43-dev mailing list [email protected] http://lists.infradead.org/mailman/listinfo/b43-dev
