Lowe, Bryan wrote:
> Hello List-
>
> I’m a bacula newbie that inherited this bacula setup from my
> predecessor. It seems to work very well.
>
> I have 3 separate tape drives for 3 separate backup pools. They are
> Oracle, Unix, and Images. All 3 are set up exactly the same way, except
> the Oracle jobs run nightly while the Unix and Images jobs only run once
> a week.
>
> I’m having a problem with my Oracle backups that I can’t seem to put my
> finger on. I’m using SuperDLT tapes, 160GB/320GB. However, when bacula
> writes to the tape, it says that the tape is full only after writing
> less than 1GB! Sometimes it will only write like 7MB! Then it prompts me
> for the next available tape. I can verify that I’m not having this
> problem if dumping directly to tape from command line. I also tried
> putting through a cleaning tape. Does anyone have any idea what could
> cause this, or where I should start looking?
Are they marked "Full" or "Used"?
What does your Pool configuration look like?
--
Phil Stracchino [EMAIL PROTECTED]
Renaissance Man, Unix generalist, Perl hacker
Mobile: 603-216-7037 Landline: 603-886-3518
-------------------------------------------------------
This SF.Net email is sponsored by:
Power Architecture Resource Center: Free content, downloads, discussions,
and more. http://solutions.newsforge.com/ibmarch.tmpl
_______________________________________________
Bacula-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bacula-users
