On Sun, Oct 14, 2012 at 10:49:23PM +0200, Jean-Christophe PLAGNIOL-VILLARD wrote: > from linux 3.6 > > Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <[email protected]> > --- > drivers/mtd/devices/Kconfig | 18 + > drivers/mtd/devices/Makefile | 1 + > drivers/mtd/devices/mtd_dataflash.c | 882 > +++++++++++++++++++++++++++++++++++ > include/spi/flash.h | 2 +- > 4 files changed, 902 insertions(+), 1 deletion(-) > create mode 100644 drivers/mtd/devices/mtd_dataflash.c > > diff --git a/drivers/mtd/devices/Kconfig b/drivers/mtd/devices/Kconfig > index e6d747c..e956921 100644 > --- a/drivers/mtd/devices/Kconfig > +++ b/drivers/mtd/devices/Kconfig > @@ -1,6 +1,24 @@ > menu "Self contained MTD devices" > depends on MTD!=n > > +config MTD_DATAFLASH > + tristate "Support for AT45xxx DataFlash" > + depends on SPI > + help > + This enables access to AT45xxx DataFlash chips, using SPI. > + Sometimes DataFlash chips are packaged inside MMC-format > + cards; at this writing, the MMC stack won't handle those. > + > +config MTD_DATAFLASH_WRITE_VERIFY > + bool "Verify DataFlash page writes" > + depends on MTD_DATAFLASH > + help > + This adds an extra check when data is written to the flash. > + It may help if you are verifying chip setup (timings etc) on > + your board. There is a rare possibility that even though the > + device thinks the write was successful, a bit could have been > + flipped accidentally due to device wear or something else. > +
What about MTD_DATAFLASH_OTP? Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox
