The DT file from the linux kernel uses mmc0 for SD card, but the evaluation board uses mmc1. Fix DT file so it has same behaviour like the non-DT version where mmc1 is used.
Signed-off-by: Sam Ravnborg <[email protected]> --- arch/arm/dts/at91sam9263ek.dts | 15 ++++++++------- 1 file changed, 8 insertions(+), 7 deletions(-) diff --git a/arch/arm/dts/at91sam9263ek.dts b/arch/arm/dts/at91sam9263ek.dts index 224748ecc..7d0ae0447 100644 --- a/arch/arm/dts/at91sam9263ek.dts +++ b/arch/arm/dts/at91sam9263ek.dts @@ -55,12 +55,13 @@ status = "okay"; }; - mmc0: mmc@fff80000 { + mmc1: mmc@fff84000 { pinctrl-0 = < - &pinctrl_board_mmc0 - &pinctrl_mmc0_clk - &pinctrl_mmc0_slot0_cmd_dat0 - &pinctrl_mmc0_slot0_dat1_3>; + &pinctrl_board_mmc1 + &pinctrl_mmc1_clk + &pinctrl_mmc1_slot0_cmd_dat0 + &pinctrl_mmc1_slot0_dat1_3>; + cd-gpios = <&pioE 18 GPIO_ACTIVE_HIGH>; status = "okay"; slot@0 { reg = <0>; @@ -71,8 +72,8 @@ }; pinctrl@fffff200 { - mmc0 { - pinctrl_board_mmc0: mmc0-board { + mmc1 { + pinctrl_board_mmc1: mmc1-board { atmel,pins = <AT91_PIOE 18 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_UP_DEGLITCH /* PE18 gpio CD pin pull up and deglitch */ AT91_PIOE 19 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_UP>; /* PE19 gpio WP pin pull up */ -- 2.12.0 _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox
