Hello,
I have updated my barebox image on a imx6ul board and since then I
cannot update it again.
I think I might have left something out in the barebox config last
time but I do not know what.
I try to do the following:
barebox_update -y -t /mnt/disk0.0/barebox.bin
ocotp0.permanent_write_enable=1
mw -l -d /dev/imx-ocotp 0x14 x00000093
mw -l -d /dev/imx-ocotp 0x18 0x00000010
mw -l 0x20D8004 0x00000093
mw -l -d /dev/imx-ocotp 0x14 0x00000093
mw -l -d /dev/imx-ocotp 0x18 0x00000010
md 0x20D8004+4
and the output is:
Image Metadata:
build: #1 Fri Nov 9 03:15:37 PST 2018
release: 2018.04.0
parameter: memsize=512
imx-bbu-nand-fcb: imx_bbu_nand_update: No FCB device!
barebox_update: No such device
ocotp0: reloading shadow registers...
ocotp0: reloading shadow registers...
020d8004: 00000093 ....
barebox@Phytec phyCORE-i.MX6 Ultra Lite SOM:/ ls /dev/
cs0 disk0
disk0.0 eeprom0
full imx-ocotp
mdio0-phy01 mem
nand0 nand0.bb
nand0.nand-env nand0.nand-env.bb
nand0.nand-factory nand0.nand-factory.bb
nand0.nand-fit1 nand0.nand-fit1.bb
nand0.nand-fit2 nand0.nand-fit2.bb
nand0.nand-fsbl-uboot nand0.nand-fsbl-uboot.bb
nand0.nand-maker nand0.nand-maker.bb
nand0.oob nand0.raw
netconsole-1 null
prng ram0
serial0-1 zero
barebox@Phytec phyCORE-i.MX6 Ultra Lite SOM:/
What could the reason for the bolded error messages?
Thanks,
Mihaita
_______________________________________________
barebox mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/barebox
