On 24-01-22, Ahmad Fatoum wrote:
> ddrphy_init_set_dfi_clk() is called to translate a scalar clock rate
> as specified by board code into PLL parameters, which are configured.
>
> enum ddr_rate describes the possible DDR rates and so far
> ddrphy_init_set_dfi_clk() supported all of them, except for 2600 and
> 2376 MHz, rendering these two rates unusable.
>
> Fix this by adding support for them into ddrphy_init_set_dfi_clk.
Do we need to support this in TF-A as well for dvfs?
> Signed-off-by: Ahmad Fatoum <a.fat...@pengutronix.de>
The barebox change itself lgtm, therefore:
Reviewed-by: Marco Felsch <m.fel...@pengutronix.de>
> ---
> drivers/ddr/imx/imx8m_ddr_init.c | 6 ++++--
> 1 file changed, 4 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/ddr/imx/imx8m_ddr_init.c
> b/drivers/ddr/imx/imx8m_ddr_init.c
> index 8b829645c063..d9a5d589f27b 100644
> --- a/drivers/ddr/imx/imx8m_ddr_init.c
> +++ b/drivers/ddr/imx/imx8m_ddr_init.c
> @@ -219,9 +219,9 @@ enum ddr_rate {
> DDR_3720,
> DDR_3200,
> DDR_3000,
> - DDR_2600, /* Unused */
> + DDR_2600,
> DDR_2400,
> - DDR_2376, /* Unused */
> + DDR_2376,
> DDR_1600,
> DDR_1000, /* Unused */
> DDR_1066,
> @@ -450,7 +450,9 @@ static void ddrphy_init_set_dfi_clk(struct
> dram_controller *dram, unsigned int d
> case 3720: drate = DDR_3720; break;
> case 3200: drate = DDR_3200; break;
> case 3000: drate = DDR_3000; break;
> + case 2600: drate = DDR_2600; break;
> case 2400: drate = DDR_2400; break;
> + case 2376: drate = DDR_2376; break;
> case 1600: drate = DDR_1600; break;
> case 1066: drate = DDR_1066; break;
> case 667: drate = DDR_667; break;
> --
> 2.39.2
>
>
>
