-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Hi i have a problem to see an Dlink ap900+ in my house (that have the
latest revision "B" firmware and basic ap configuration)
i have a zd1211 usb dongle and my onboard 4311PCIE (the zydas dongle
connect fine, but not the 4311)
wlan1 : zd1211rw
eth1: bcm43xx
i can connect to another ap (Noganet vendor), but not here
ntbkragnarok:/usr/src# iwlist wlan1 s
wlan1 Scan completed :
Cell 01 - Address: 00:80:C8:AC:AA:06
ESSID:"docksud"
Protocol:IEEE 802.11b
Mode:Master
Channel:6
Encryption key:off
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 22 Mb/s
Quality=100/100 Signal level=82/100
Extra: Last beacon: 180ms ago
ntbkragnarok:/usr/src# iwlist eth1 s
eth1 No scan results
ntbkragnarok:/usr/src#
ACPI: PCI Interrupt 0000:10:00.0[A] -> GSI 17 (level, low) -> IRQ 17
PCI: Setting latency timer of device 0000:10:00.0 to 64
bcm43xx: Chip ID 0x4311, rev 0x1
bcm43xx: Number of cores: 4
bcm43xx: Core 0: ID 0x800, rev 0x11, vendor 0x4243, enabled
bcm43xx: Core 1: ID 0x812, rev 0xa, vendor 0x4243, disabled
bcm43xx: Core 2: ID 0x817, rev 0x3, vendor 0x4243, disabled
bcm43xx: Core 3: ID 0x820, rev 0x1, vendor 0x4243, enabled
bcm43xx: PHY connected
bcm43xx: Detected PHY: Version: 4, Type 2, Revision 8
bcm43xx: Detected Radio: ID: 2205017f (Manuf: 17f Ver: 2050 Rev: 2)
bcm43xx: Radio turned off
bcm43xx: Radio turned off
bcm43xx: PHY connected
bcm43xx: Microcode rev 0x127, pl 0xe (2005-04-18 02:36:27)
bcm43xx: Radio turned on
bcm43xx: Radio disabled by hardware
bcm43xx: Chip initialized
bcm43xx: 32-bit DMA initialized
bcm43xx: Keys cleared
bcm43xx: Selected 802.11 core (phytype 2)
bcm43xx: Radio hardware status changed to enabled
SoftMAC: Start scanning with channel: 1
SoftMAC: Scanning 14 channels
SoftMAC: Scanning finished
SoftMAC: Start scanning with channel: 1
SoftMAC: Scanning 14 channels
SoftMAC: Scanning finished
SoftMAC: Start scanning with channel: 1
SoftMAC: Scanning 14 channels
SoftMAC: Scanning finished
i test it on 2.6.19.2 (with the las two larry patches for 2.6.19.1)
these patch's was apply succesfully on 2.6.19.2
ntbkragnarok:/usr/src# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11b/g ESSID:"docksud" Nickname:"Broadcom 4311"
Mode:Managed Frequency=2.484 GHz Access Point: Invalid
Bit Rate=1 Mb/s Tx-Power=18 dBm
RTS thr:off Fragment thr:off
Encryption key:off
Link Quality=0/100 Signal level=-256 dBm Noise level=-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
wlan1 IEEE 802.11b/g ESSID:"docksud" Nickname:"zd1211"
Mode:Managed Frequency:2.437 GHz Access Point:
00:80:C8:AC:AA:06
Bit Rate=11 Mb/s
Encryption key:off
Link Quality=60/100 Signal level=24/100
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Saludos!
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.6 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
iD8DBQFFsWxvz8H9Vs7bTsMRAty+AJ4oR5cRPmEyTzLk1BBCU88W3O80ogCfVlvH
j2krhHGSJcL8mIlrWfPAj8M=
=doPd
-----END PGP SIGNATURE-----
_______________________________________________
Bcm43xx-dev mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
