On Wed, 2007-04-11 at 00:19 -0400, David Woodhouse wrote:
> I figured if people were going to start working more on the mac80211
> driver than the softmac one, I probably ought to start reporting the
> cases where it kills my machine. So I hacked up ssb_pci_{read,write}16
> to use outw instead of readw and thus get their machine checks
> trapped.
>
> This is what I found...
Then the performance was poor and NetworkManager kept getting
disconnected. I'd have tried forcing the rate down to 11Mb/s or lower,
but my iwconfig didn't seem to work because it was too old. I'll
investigate that later.
I saw this at one point too..
> <3>bcm43xx_mac80211: !WARNING! Idle-TSSI phy->cur_idle_tssi measuring
> failed. (cur=0, tgt=62). Disabling TX power adjustment.
I also didn't get IPv6 addresses by RA... at least until I tried to
investigate. Perhaps it was the tcpdump which made it work -- perhaps
multicast is broken and I only picked up the address when I put it in
promiscuous mode?
--
dwmw2
_______________________________________________
Bcm43xx-dev mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
