Larry Finger wrote: > Ioannis Nousias wrote: >> iwconfig: >> eth1 IEEE 802.11b/g ESSID:"<My ESSID here>" Nickname:"Broadcom >> 4306" >> Mode:Managed Frequency=2.432 GHz Access Point: <my >> router's MAC here> Bit Rate=24 Mb/s Tx-Power=14 >> dBm RTS thr:off Fragment thr:off > > Your interface has not authenticated. If it had, there would be an > encryption key here. > >> Link Quality=66/100 Signal level=-61 dBm Noise level=-66 dBm > > This is a low signal/noise. Attached is a patch that will cut the rate > from 24M to 11M to see if that helps get you connected. > >> Rx invalid nwid:0 Rx invalid crypt:1 Rx invalid frag:0 >> Tx excessive retries:0 Invalid misc:0 Missed beacon:0 >> >> >> I'm not sure. Is there a log? nm-tool reports this: > > In the panel kicker applet used with NM on KDE, I get a progression > bar. I guess it isn't universal. > >> >> But, I think it reloads itself. In fact I can see it in dmesg. Is it >> possible that NM causes it to reload the module ? > > I don't think NM is doing it by itself. At least it doesn't do that on > my system. When I unload the module, I have to manually reload it, and > then reconnect. > > Larry >
Thanks, but no luck. I even tried with 1Mbps and still can't connect. with 11Mbps: Link Quality=58/100 Signal level=-64 dBm Noise level=-67 dBm with 1Mbps: Link Quality=68/100 Signal level=-59 dBm Noise level=-65 dBm -Ioannis PS: I can see wpa_supplicants being invoked by NM, so that part should be ok. root 5202 0.0 0.1 4948 1388 ? S 08:46 0:00 /usr/sbin/wpa_supplicant -g /var/run/wpa_supplicant-global _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
