Since addition of the rfkill callback, the LED associated with the off
switch on the radio has not worked for several reasons:
(1) Essential data in the rfkill structure were missing.
(2) The rfkill structure was initialized after the LED initialization.
(3) There was a minor memory leak if the radio LED structure was inited.
Once the above problems were fixed, additional difficulties were noted:
(4) The radio LED was in the wrong state at startup.
(5) The radio switch had to be manipulated twice for each state change.
(6) A circular mutex locking situation existed.
This patch fixes all of the above.
Signed-off-by: Larry Finger <[EMAIL PROTECTED]>
---
John and Michael,
These changes are mostly obvious. The most complicated is the fixing of the
circular locking between the rfkill and wl_dev mutexes. This was acomplished
by moving the rfkill_init() call to the beginning of b43_op_start() and the
rfkill_exit() call to the end of b43_op_stop().
Techically, these changes are fixes for the radio LED regression between
bcm43xx and b43. It doesn't matter to me if they are pushed into 2.6.24, or
left for 2.6.25.
Larry
---
leds.c | 1 +
main.c | 25 +++++++++++++++----------
rfkill.c | 14 ++++++++++++--
3 files changed, 28 insertions(+), 12 deletions(-)
Index: wireless-2.6/drivers/net/wireless/b43/rfkill.c
===================================================================
--- wireless-2.6.orig/drivers/net/wireless/b43/rfkill.c
+++ wireless-2.6/drivers/net/wireless/b43/rfkill.c
@@ -60,8 +60,12 @@ static void b43_rfkill_poll(struct input
}
mutex_unlock(&wl->mutex);
- if (unlikely(report_change))
- input_report_key(poll_dev->input, KEY_WLAN, enabled);
+ /* send the radio switch event to the system - note both a key press
+ * and a release are required */
+ if (unlikely(report_change)) {
+ input_report_key(poll_dev->input, KEY_WLAN, 1);
+ input_report_key(poll_dev->input, KEY_WLAN, 0);
+ }
}
/* Called when the RFKILL toggled in software. */
@@ -133,6 +137,12 @@ void b43_rfkill_init(struct b43_wldev *d
rfk->poll_dev->poll = b43_rfkill_poll;
rfk->poll_dev->poll_interval = 1000; /* msecs */
+ rfk->poll_dev->input->name = rfk->name;
+ rfk->poll_dev->input->id.bustype = BUS_HOST;
+ rfk->poll_dev->input->id.vendor = dev->dev->bus->boardinfo.vendor;
+ rfk->poll_dev->input->evbit[0] = BIT(EV_KEY);
+ set_bit(KEY_WLAN, rfk->poll_dev->input->keybit);
+
err = rfkill_register(rfk->rfkill);
if (err)
goto err_free_polldev;
Index: wireless-2.6/drivers/net/wireless/b43/main.c
===================================================================
--- wireless-2.6.orig/drivers/net/wireless/b43/main.c
+++ wireless-2.6/drivers/net/wireless/b43/main.c
@@ -2156,7 +2156,6 @@ static void b43_mgmtframe_txantenna(stru
static void b43_chip_exit(struct b43_wldev *dev)
{
b43_radio_turn_off(dev, 1);
- b43_leds_exit(dev);
b43_gpio_cleanup(dev);
/* firmware is released later */
}
@@ -2184,11 +2183,10 @@ static int b43_chip_init(struct b43_wlde
err = b43_gpio_init(dev);
if (err)
goto out; /* firmware is released later */
- b43_leds_init(dev);
err = b43_upload_initvals(dev);
if (err)
- goto err_leds_exit;
+ goto err_gpio_clean;
b43_radio_turn_on(dev);
b43_write16(dev, 0x03E6, 0x0000);
@@ -2267,8 +2265,7 @@ out:
err_radio_off:
b43_radio_turn_off(dev, 1);
-err_leds_exit:
- b43_leds_exit(dev);
+err_gpio_clean:
b43_gpio_cleanup(dev);
return err;
}
@@ -2703,7 +2700,8 @@ static int b43_antenna_from_ieee80211(u8
static int b43_op_config(struct ieee80211_hw *hw, struct ieee80211_conf *conf)
{
struct b43_wl *wl = hw_to_b43_wl(hw);
- struct b43_wldev *dev;
+ struct b43_rfkill *rfk = &(wl->rfkill);
+ struct b43_wldev *uninitialized_var(dev);
struct b43_phy *phy;
unsigned long flags;
unsigned int new_phymode = 0xFFFF;
@@ -2802,6 +2800,13 @@ static int b43_op_config(struct ieee8021
out_unlock_mutex:
mutex_unlock(&wl->mutex);
+ /* if a LED is devoted to the radio and the switch is on, send
+ * KEY_WLAN press/release keystrokes */
+ if (!err && dev->radio_hw_enable && &dev->led_radio) {
+ input_report_key(rfk->poll_dev->input, KEY_WLAN, 1);
+ input_report_key(rfk->poll_dev->input, KEY_WLAN, 0);
+ }
+
return err;
}
@@ -3284,9 +3289,7 @@ static void b43_wireless_core_exit(struc
return;
b43_set_status(dev, B43_STAT_UNINIT);
- mutex_unlock(&dev->wl->mutex);
- b43_rfkill_exit(dev);
- mutex_lock(&dev->wl->mutex);
+ b43_leds_exit(dev);
b43_rng_exit(dev->wl);
b43_pio_free(dev);
@@ -3409,8 +3412,8 @@ static int b43_wireless_core_init(struct
memset(wl->mac_addr, 0, ETH_ALEN);
b43_upload_card_macaddress(dev);
b43_security_init(dev);
- b43_rfkill_init(dev);
b43_rng_init(wl);
+ b43_leds_init(dev);
b43_set_status(dev, B43_STAT_INITIALIZED);
@@ -3503,6 +3506,7 @@ static int b43_op_start(struct ieee80211
int did_init = 0;
int err = 0;
+ b43_rfkill_init(dev);
mutex_lock(&wl->mutex);
if (b43_status(dev) < B43_STAT_INITIALIZED) {
@@ -3537,6 +3541,7 @@ static void b43_op_stop(struct ieee80211
b43_wireless_core_stop(dev);
b43_wireless_core_exit(dev);
mutex_unlock(&wl->mutex);
+ b43_rfkill_exit(dev);
}
static int b43_op_set_retry_limit(struct ieee80211_hw *hw,
Index: wireless-2.6/drivers/net/wireless/b43/leds.c
===================================================================
--- wireless-2.6.orig/drivers/net/wireless/b43/leds.c
+++ wireless-2.6/drivers/net/wireless/b43/leds.c
@@ -232,4 +232,5 @@ void b43_leds_exit(struct b43_wldev *dev
b43_unregister_led(&dev->led_tx);
b43_unregister_led(&dev->led_rx);
b43_unregister_led(&dev->led_assoc);
+ b43_unregister_led(&dev->led_radio);
}
_______________________________________________
Bcm43xx-dev mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
