Felipe Sere wrote: > Hi everyone, > > I am new to this list, so please be gentle :-) I am also no kernel developer. > > My problem is the following: > even though I have extracted the firmware for the bcm from a file from > the inet (wl_apasta.o or so) to /lib/firmware and the module loads > without any errors when I do a modprobe b43, ifconfig -a does not show > any new interface... > I think the problem lies with the PCIID of my wireless chip. > Here is the output of lspci -nnv concerning the Broadcome BCM43xx chip. > 0b:00.0 Network controller [0280]: Broadcom Corporation BCM4328 > 802.11a/b/g/n [14e4:4328] (rev 05) > Subsystem: Apple Computer Inc. Unknown device [106b:008c] > Flags: bus master, fast devsel, latency 0, IRQ 16 > Memory at 97300000 (64-bit, non-prefetchable) [size=16K] > Capabilities: [40] Power Management version 3 > Capabilities: [58] Vendor Specific Information <?> > Capabilities: [e8] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 > Enable- > Capabilities: [d0] Express Endpoint, MSI 00 > Kernel driver in use: b43-pci-bridge > Kernel modules: ssb > > I am willing to give any other needed information and help with > testing some patches.
At the moment, the BCM4328 is not supported by any b43 driver. The reverse engineering for this chip is in progress, but we cannot promise a date at which the driver will support this chip. Larry _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
