Did you use camera LI-LBCM5M1 successfully? could you guide me in detail. I have done it for a week which drive me on the wall.
在 2012年12月17日星期一UTC+8下午4时55分34秒，[email protected]写道： > > Dear Willem, > I'm using beagleboard xm with the camera LI LBCM5M1 and I follow your > instructions on the above, > but I really don't know how to get the latest uboot.bin and how to place > this uboot on the BB-xm. > Would you please give some more details about how todos? > > Thank you very much! > > 在 2012年1月11日星期三UTC+8上午3时13分27秒，Willem写道： >> >> > Is there any changes that we need to make in the hardware? like adding >> > a resistor or shorting 2 pins or the like?? >> No. >> >> I used Angstrom 2.6.32 that the board was shipped with and the latest >> U-Boot then installed the camera driver: >> #opkg install kernel-module-mt9p031 >> >> At the U-Boot prompt: >> setenv camera lbcm5m03 >> >> Willem >> > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
