On Wed, Oct 30, 2013 at 4:49 PM, <[email protected]> wrote: > Heya, I have been experimenting with different distro's on the BBB, trying > to find the one that works for what I want. Gotta admit this thing is > touchy and cumbersome, sometimes boot's, sometimes doesn't. Now upon trying > to flash the emmc I get four user led's blinking synchronously! The only > doc's I can find on this state that I have used up my limit flashing the > emmc. Please tell me this isn't true?!?! If so, this would be absurd to me > as I have only re-flashed it under ten times. > > Can someone please advise if this is the case, or is there something else > wrong? I don't have a serial connection and don't want to waste any money > on getting one to see the error code if this is in fact the case!
Ahh, as you don't specify which image, that sounds like my ubuntu/debian image. (please confirm which image you used...) First make sure NO capes are installed. You can leave the ethernet plugged in but nothing else, not even the 'expansion' cape board.. Make sure your using 5Volt DC power. I only have one board that shows the same issue, but it was a very very early pre-production one.. (The eMMC on that one had been re-written way to many times..) Regards, -- Robert Nelson http://www.rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
