Thanks Gerald. I'm using this schematic https://github.com/CircuitCo/BeagleBone-Black-RevA5A/blob/master/BBB_SCH.pdf?raw=true
I'm trying to plug my device on the SDA and SCL pins of U7 (EEPROM). On Wednesday, November 27, 2013 4:27:32 PM UTC-2, Gerald wrote: > > You got a schematic? > > Gerald > > > On Wed, Nov 27, 2013 at 10:55 AM, <[email protected] <javascript:>>wrote: > >> Hi, >> I'm working on a project that uses 6 MPU6050 to detect body motion and I >> can connect 4 of them on the beaglebone using the 2 i2c channels available >> by PINs. >> But I need to connect 2 more, so I was trying to solder right on the >> board and access the i2c-0, and when I did, I successfuly detected using >> i2cdetect -y -r 0, but just for a short amount of time. >> Why it worked for just a brief moment? >> How the i2c-0 works? >> Why the i2c-0 is different than others i2c channels? >> And finally, the golden question, how can I make it work? >> >> >> PS.: I'm ashamed to have posted a lot of questions on my first post on >> this forum. >> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> For more options, visit https://groups.google.com/groups/opt_out. >> > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
