I have been using my BBB rev A5 without any problems. Today I received my new rev A6 BBB. I went to perform the upgrade like i did with the A5 using the SD card. However on the A6 its does not work. I get the following at the terminal on rev A6 with the same sd card that i just upgraded the A5 with.
U-Boot SPL 2013.04-dirty (Jun 19 2013 - 09:57:14) musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Peripheral mode controller at 47401000 using PIO, IRQ 0 musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Host mode controller at 47401800 using PIO, IRQ 0 OMAP SD/MMC: 0 ** Partition 1 not valid on device 0 ** spl: fat register err - -1 ### ERROR ### Please RESET the board ### I am using BBB-eMMC-flasher-2013.09.04.img I have even tried taking the same image file and using Win32DiskImager again on the A6 board, but i get the same results. Any ideas ?? -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
