Does the board boot from the eMMC? Gerald
On Wed, Dec 11, 2013 at 8:52 PM, <[email protected]> wrote: > I have been using my BBB rev A5 without any problems. > Today I received my new rev A6 BBB. I went to perform the upgrade like i > did with the A5 using the SD card. However on the A6 its does not work. I > get the following at the terminal on rev A6 with the same sd card that i > just upgraded the A5 with. > > U-Boot SPL 2013.04-dirty (Jun 19 2013 - 09:57:14) > musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, > SoftConn) > musb-hdrc: MHDRC RTL version 2.0 > musb-hdrc: setup fifo_mode 4 > musb-hdrc: 28/31 max ep, 16384/16384 memory > USB Peripheral mode controller at 47401000 using PIO, IRQ 0 > musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, > SoftConn) > musb-hdrc: MHDRC RTL version 2.0 > musb-hdrc: setup fifo_mode 4 > musb-hdrc: 28/31 max ep, 16384/16384 memory > USB Host mode controller at 47401800 using PIO, IRQ 0 > OMAP SD/MMC: 0 > ** Partition 1 not valid on device 0 ** > spl: fat register err - -1 > ### ERROR ### Please RESET the board ### > > > > I am using BBB-eMMC-flasher-2013.09.04.img > I have even tried taking the same image file and using Win32DiskImager > again on the A6 board, but i get the same results. > > Any ideas ?? > > > > > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/groups/opt_out. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
