Use Figure 38 in the in the rev A6 manual. Gerald
On Thu, Dec 19, 2013 at 2:35 PM, Gerald Coley <[email protected]>wrote: > I will add it to my list of things to look at. > > Gerald > > > > On Thu, Dec 19, 2013 at 2:18 PM, moore.cyril <[email protected]>wrote: > >> Hi guys, >> >> I was having trouble booting my BBB with a LCD connected. I was trying to >> confirm that the SYS_BOOT pins, which are also the LCD data pins, matched >> what the SRM said. After a little testing I found that the SYS_BOOT pins >> never totally matched the SRM even with the LCD disconnected. After a >> little more digging I found that there is a discrepancy between the BBB SRM >> and the Beaglebone Black Schematics. I am using the Rev A6 schematics dated >> September 11, 2013 and the Rev A6 SRM dated October 11, 2013. The sheet 6 >> of the schematic shows the SYS_BOOT pins configured to what is on the >> Beaglebone Black that I have (Its a rev A5B). On page 104 of the SRM it >> shows different resistor numbers and a different configuration of which >> ones are DNI. >> >> Just wanted let you guys know what I found. >> >> Cheers >> >> >> >> -- >> For more options, visit http://beagleboard.org/discuss >> --- >> You received this message because you are subscribed to the Google Groups >> "BeagleBoard" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> For more options, visit https://groups.google.com/groups/opt_out. >> > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
