On Fri, Jan 3, 2014 at 4:33 PM, William Hermans <[email protected]> wrote: > Robert, I would not mind helping out, if I can, I just do not know where to > start. Actual testing, I would think you'd want some one familiar with a > scope / LA, and that person is not me. YET. > > Pretty much what I need in the end is all UARTs, all I2C, and all SPI > enabled. My buddy and I have a project that uses every single last pin, and > then some . . . but anyhow I would like to help If i can. My own motivation > would be to get what I want, and the benefit to the community would be every > one gets to use whatever I put together.
if you guys can write up spreadsheet with what pins you need that will be great.. So far what i've done with rscm was the result of beer & new years. ;) My current goal, default dts setup for: http://elinux.org/Basic_Proto_Cape Out of the box. Then we can dynamically patch what we can into it.. So far this is just i2c/uart.. (have a wip spi enable, but it locks up..) Then a minimal dts (aka no hdmi), then we can patch a lot more into.. Finally a discrete dts for capes that can't be patched for above.. So that's the plan, and in 13mins i'll be away from keyboard till sunday.. so maybe next week .;) Regards, -- Robert Nelson http://www.rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
