I am trying to flash my Beaglebone Black with Debain flasher image available at https://rcn-ee.net/deb/flasher/wheezy/BBB-eMMC-flasher-debian-7.3-2013-12-17-2gb.img.xz
But I am not able to do it. I am holding the boot button and then turning on the power supply for the board. The LEDs doesn't turn on even after a long time as I am holding the boot button. I tried to look into what is happening with the help of Serial to USB converter and go the message displayed bellow: U-Boot SPL 2013.10-00015-gab7a95a (Nov 08 2013 - 16:01:27) i2c_probe: pads on bus 0 probably not configured (status=0x10) Could not probe the EEPROM; something fundamentally wrong on the I2C bus. Could not get board ID. i2c_probe: pads on bus 0 probably not configured (status=0x10) Could not probe the EEPROM; something fundamentally wrong on the I2C bus. Could not get board ID. Unknown board, cannot configure pinmux.### ERROR ### Please RESET the board ### Does anyone know how to solve this issue. This is not the case only with Debian image. I am not able to boot from any image. I can only run the image Angstrom Distribution (BeagleBone, BeagleBone Black - 4GB SD) 2013-06-20<https://s3.amazonaws.com/angstrom/demo/beaglebone/Angstrom-Cloud9-IDE-GNOME-eglibc-ipk-v2012.12-beaglebone-2013.06.20.img.xz> available at http://beagleboard.org/latest-images. This image also doesn't boot up, if I press the boot button. It boots up automatically if I insert the sd card with the image in the beaglebone black and give power supply, without me pressing the boot button. And my Beaglebone black doesn't boot from eMMC also. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
